corpse cart assembly question

[maddipper]

i was looking over the corpse cart sprues & i found 2 items that i have a question about. the 1st is an item with what looks like rope, a head, & an item that is square with a point on it & what looks like a spine at the bottom. the other is 3 heads with a hook through them and again some rope. i can't find this piece shown on the instructions & i have not seen it in pics. what are they? where do they fit in on the model? thanks for your help

 

[Lynks]

Is the rope a little curved? if so i think you may be talking about the optional extra pieces that get attached to the back of the corpse cart and drag along the ground.

 

[maddipper]

Is the rope a little curved? if so i think you may be talking about the optional extra pieces that get attached to the back of the corpse cart and drag along the ground.

yea they are a little curved. is there any special spot on the back or is it just where they fit?

 

[Lynks]

Mine is packed away and I don't recall where I attached them, or if they had a specific spot to go in unfortunately

 

[krinas]

I desided not to use them at all . but I remember a pic I saw somewhere on the internet that had the heads with the spike glued behind the right wheel where the metal bar that keeps the corpse cart together ends. hope it helps, If I stamble to that pic again I am gonna post it.

 

[Normal]

They are to be glued between last wood rib and the suport for the balefire/bell, one in each side. there´s an optimum angle to do this, just try out and you´ll see when there will be a match.