RE: Bullhax's VC plog - Special guests may appear
A new little update in the Ogre Kingdom department, 4 models was all I had time for since the last time and it only came down to a couple of arm and weapon/hand swaps...
Also I've had my first experience with the horrors that is finecast...
I've heard/read a lot of horrible stuff about it but decided to give it the benefit of the doubt as I really wanted the Firebelly model and couldn't find it in metal close by.. That stuff is pure crap, blebs, holes, funky bends and more-annoying-than-plastic mould lines.. There was a horrible bend to the lower part of the hammer that I tried to smoothe out, I didn't use hot enough water though, my own damn fault so it snapped right off... I tried to make it into something positive and swapped the ends with the two handed hammer on my Crusher as the end left here was to small to make it believable.
It will be a while before I dive into buying a new FC model again if ever.!
I instead used the little spare time I had left in hollowing out a Chaos Warrior helm that will be featured on the Gutlords base to tie the two together.. It will be placed in the murky water to look like it flew off and got stuck in the muck when my Vampire Lord struck the unfortunate chaos warrior. Will include a picture of this when the whole model gets done as I wont pin them till both base and model is painted..
Here's some pictures of the models I've assembled:
Crusher:
Standard Bearer:
Bellower:
Stupid finecrap "!#!#%"#, but awesomely sculpted so i guess I'm happy overall Firebelly:
The bellower got his weapon from the Crypt Horror kit, the crusher got an irongut hammer and a ironfist from the Mournfang kit..
The standard bearer got an arm from the Mournfang kit, and a weapon swap from the offhand selection on the Ogre-sprue..!
When I have more time I will burn some flesh wounds on some of the models backs/arms and greenstuff the gaps from the swaps. Now exam friday and getting hammered afterwards!