So I have over the years experimented with various different ways of stripping paint.
I have used Simple Green, Dishwashing Liquid and Windex... but none of them did me much good.
Until I happened along to articles about paint stripping with dettol- so I decided to give it a try, and here is what I found.
I have used Simple Green, Dishwashing Liquid and Windex... but none of them did me much good.
Until I happened along to articles about paint stripping with dettol- so I decided to give it a try, and here is what I found.
WHAT YOU NEED
WARNINGS
Before we start, here are some important warnings.
- Some painted models to strip. Metal, Plastic or Resin, it doesn't matter.
- Some Dettol. Not the clear stuff, the brown stuff.
- A toothbrush. I bought a cheap electric toothbrush to save me some effort, but any cheap or old toothbrush will do.
- Other tools for scraping paint of things- toothpicks, old used up brushes, dental tools if you have them, etc etc.
- Dishwashing Liquid
- Some buckets and/or containers to put things in.
WARNINGS
Before we start, here are some important warnings.
- This warning is the most important. At some points you may be tempted to rinse the models or toothbrush is water. At no point during the process should you do this! If you introduce water to a model that has been soaked in dettol, it will form a gluey, tarry residue which is difficult to remove from the model, and over which paint won't really stick properly. I will cover how to properly rinse things later in this guide.
- Be aware that the dettol solution, and your models, will have a very strong smell. I would advise wearing some decent gloves while doing all of this. However, as far as I can tell it is no where near as harmful as other paint strippers (like break fluid) can be. Use a well ventilated area.
ONTO THE FUN STUFF
THE RESULTS
If you follow the steps correctly, you will generally find that plastic models will be stripped bare- even paint in the crevices can be reliably removed!
I have not yet tried it on metal, but I have been told that metal models come out even shinier than they originally were.
- First, you need to prepare the dettol solution. In your planned soaking container, mix a 1:1 solution of the Dettol & water. It will look kinda foamey and white. (And it will stink to high heaven)
- Next, get any models you wish to strip, and immerse them in the solution.
- Leave them in the solution for a few hours (though it is best to leave them for 24 hours/overnight). Do this with a sealable container, or leave it somewhere were the fumes won't get to you.
- Once the models have been soaked, its time to get all of that paint off. It should come of fairly easily- just scrub the models with a toothbrush, and use a toothpick or dental tools or whatever to get the gunky paint out from any crevices.
- If you need to rinse the models, or the toothbrush, rinse them in the dettol solution- remember, we can't introduce water to these models!
- Once you have gotten rid of all of the paint that you can, its time to rinse the models!
- In another container or bucket (or even a sink) mix some dishwashing liquid with warm (but not hot) water.
- Rinse the models in this dishwashing liquid/warm water solution.
- Check the models for any remaining gunk and residue- if theres still gunk or residue of any kind, you need to scrub them some more and rinse them again until its all gone, or even return them to the dettol for more soaking.
THE RESULTS
If you follow the steps correctly, you will generally find that plastic models will be stripped bare- even paint in the crevices can be reliably removed!
I have not yet tried it on metal, but I have been told that metal models come out even shinier than they originally were.