I put my Crypt Horrors together today (Well mostly); First models I bothered to wash off the sprue, so I'm looking forward to noticing a difference with them. Otherwise I am either too poor at painting to notice, or the difference is so slim it isn't worth doing.
One thing I've noticed about a handful of newer models is that they often fit together in a way that I feel perhaps it would be a good idea to use green stuff (Perhaps liquid green stuff?) to close very minor cracks that can be seen. Else wise I'd probably have to go insane every time I notice them on my models :skull:
Anyone else have experience with smaller gaps on models like this? Just leave 'um? Fill with normal green stuff/liquid? Use something else entirely? I'm curious how other people tackle the issue.
It seems like it'll be a bit more of an issue for my Terrorghiest as well, since I know for a fact that the face will have a small seam once it's put together, and I am painting it as I assemble it; So I'm unsure about how to approach that situation..
On a related note, anyone have experiences involving painting over green stuff with no primer? I am pretty sure the most simple solution to my above stated issue is just going to be putting the head together on the already painted part of the neck/body and painting once it's on (And being very careful not to accidentally paint onto the already painted parts) and after I fill slight gaps. I assume it should be fine to paint on the green stuff without primer, after allowing it time to cure (Probably a good idea not to jump the gun on that part).
Maannn theses Crypt Horrors look amazing though! It's so painful knowing that 3 more cost nearly 50$ :skull: (Well a bit less, but still a ton!)
One thing I've noticed about a handful of newer models is that they often fit together in a way that I feel perhaps it would be a good idea to use green stuff (Perhaps liquid green stuff?) to close very minor cracks that can be seen. Else wise I'd probably have to go insane every time I notice them on my models :skull:
Anyone else have experience with smaller gaps on models like this? Just leave 'um? Fill with normal green stuff/liquid? Use something else entirely? I'm curious how other people tackle the issue.
It seems like it'll be a bit more of an issue for my Terrorghiest as well, since I know for a fact that the face will have a small seam once it's put together, and I am painting it as I assemble it; So I'm unsure about how to approach that situation..
On a related note, anyone have experiences involving painting over green stuff with no primer? I am pretty sure the most simple solution to my above stated issue is just going to be putting the head together on the already painted part of the neck/body and painting once it's on (And being very careful not to accidentally paint onto the already painted parts) and after I fill slight gaps. I assume it should be fine to paint on the green stuff without primer, after allowing it time to cure (Probably a good idea not to jump the gun on that part).
Maannn theses Crypt Horrors look amazing though! It's so painful knowing that 3 more cost nearly 50$ :skull: (Well a bit less, but still a ton!)
